Fog/Driving Lamp: Service and Repair

Fog Lamp









Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, Jacking and Lifting Service and Repair.

2. Remove the 4 bolts and the front bumper bracket.
- To install, tighten to 48 Nm (35 lb-ft).

3. Disconnect the fog lamp assembly electrical connector.

4. Remove the 3 fog lamp bracket bolts and remove the fog lamp bracket and the fog lamp assembly.
- To install, tighten to 5 Nm (44 lb-in).

5. To install, reverse the removal procedure.
- Transfer parts as necessary.

- If necessary, adjust the fog lamps. For additional information, refer to Front Fog Lamp Adjustment Adjustments.