Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> F 550 2WD Super Duty V8-6.2L Flex Fuel >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Accessories and Optional Equipment >> Communications Control Module >> Service and Repair >> Removal and Replacement >> Accessory Protocol Interface Module (APIM)

Accessory Protocol Interface Module (APIM)




Accessory Protocol Interface Module (APIM)









Removal and Installation

1. NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM is being installed to make sure that the new component is the same version as the component being replaced.

Retrieve and record the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module (APIM) Software Level Check Accessory Protocol Interface Module (APIM) Software Level Check.

2. Lower the glove compartment completely.

3. Disconnect the APIM electrical connector and the Universal Serial Bus (USB) cable electrical connector.

4. Remove the RH instrument panel side trim panel. For additional information, refer to Instrument Panel - Exploded View in Instrument Panel and Console Instrument Panel - Exploded View.

5. Remove the 2 screws and the APIM.
- Remove the APIM through the glove compartment opening.

6. To install, reverse the removal procedure.
- If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to Module Configuration Accessory Protocol Interface Module Programming.

pro multis · About Operation CHARM