Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line





Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Recover the refrigerant. For additional information, refer to Climate Control System - General Information and Diagnostics Air Conditioning (A/C) System Recovery, Evacuation and Charging.

3. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

4. Remove the compressor-to-condenser discharge line bracket nut.
- To install, tighten to 7 Nm (62 lb-in).

5. Remove the compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

6. To install, reverse the removal procedure.
- Install new O-ring seals and a new gasket seal.

- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to Climate Control System - General Information and Diagnostics Service and Repair.

7. Evacuate, leak test and charge the refrigerant system. For additional information, refer to Climate Control System - General Information and Diagnostics Air Conditioning (A/C) System Recovery, Evacuation and Charging.