Manual Control Lever Shaft Seal

Manual Control Lever Shaft Seal





Removal

1. Remove the transaxle. For additional information, refer to Transaxle Transaxle.

2. Remove and discard the manual control lever bolt and remove the manual control lever.





3. Install the special tool.





4. NOTE: Use care to prevent clutch housing cup plug from being dislodged.

Using the special tool and a suitable tool, apply slight pressure to the special tool, remove and discard the manual control lever seal.





5. Inspect the transaxle case bore for debris or damage. Clean and/or repair as needed.

Installation

1. Using the special tools, install the new manual control lever shaft seal.





2. Install the manual control lever and the new manual control lever bolt.
- Tighten to 26 Nm (19 lb-ft).





3. Install the transaxle. For additional information, refer to Transaxle Transaxle.