Power-Stow Seat Motor - Third Row

Power-Stow Seat Motor - Third Row

Removal and Installation

1. Remove the third row seat. For additional information, refer to Seat - Third Row Seat - Third Row.

2. Pry to release the clips and remove the LH and RH outboard pivot covers.

3. From the RH load floor flapper panel, detach the 2 wire harness retainers and disconnect the 2 electrical connectors. Position the wire harness out of the way.





4. From the LH load floor flapper panel, disconnect the main feed electrical connector.

5. Remove the 4 load floor panel screws on each side at the back of the cushions.

6. Pull out to release the retainers and remove the 2 load floor panels.

7. Release all cushion cover retainers from the cushion frame
- On assembly, the lower anchors and tethers for children and child safety seat tether anchor must be accessible through the cushion cover.





8. Remove the 8 cushion frame-to-pivot tube assembly bolts. Remove the pivot tube assembly with stow motors.
- To install, tighten to 60 Nm (44 lb-ft).

9. To install, reverse the removal procedure.