Pinpoint Test AH: The Key-In-Ignition Warning Chime Is Inoperative
Instrumentation, Message Center and Warning Chimes
Pinpoint Tests
Pinpoint Test AH: The Key-In-Ignition Warning Chime Is Inoperative
Refer to Wiring Diagram Set 60, Instrument Cluster for schematic and connector information. Diagrams By Number
Normal Operation
The Instrument Cluster (IC) receives the key-in-ignition warning status from the Smart Junction Box (SJB) over the Medium Speed Controller Area Network (MS-CAN) communication bus.
The key-in-ignition warning switch (part of the ignition switch) is hardwired to the SJB. When the key is inserted into the ignition lock cylinder, the key-in-ignition switch closes and supplies voltage to the SJB.
The SJB monitors the door ajar input from the LH front door and the key-in-ignition switch status. When the SJB detects a key-in-ignition voltage and the LH front door is open or ajar, the SJB sends the IC a chime request message to sound the key-in-ignition warning chime.
- DTC B1352 (Ignition Key-In Circuit Failure) - an on-demand DTC that sets in the SJB if the SJB detects an open on the key-in-ignition switch input circuit or if the SJB detects ignition START, RUN/START or RUN/ACC inputs without the key-in-ignition input.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Key-in-ignition switch (part of the ignition switch)
- SJB
- IC
PINPOINT TEST AH: THE KEY-IN-IGNITION WARNING CHIME IS INOPERATIVE
-------------------------------------------------
AH1 CARRY OUT THE CHIME FUNCTION ACTIVE COMMAND
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger .
- Select the IC chime command (CHIME_KEY).
- Does the chime operate?
Yes
GO to AH2.
No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.
-------------------------------------------------
AH2 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION
- Ignition ON.
- Open then close the LH front door while observing the door ajar warning indicator in the IC.
- Does the door ajar warning indicator operate correctly?
Yes
GO to AH3.
No
GO to Pinpoint Test R. Pinpoint Test R: The Door Ajar Warning Indicator Is Never/Always On
-------------------------------------------------
AH3 RETRIEVE THE RECORDED DTCs FROM THE SJB SELF-TEST
- Check the recorded DTCs from the SJB self-test.
- Is DTC B1352 present?
Yes
GO to AH4.
No
INSTALL a new SJB. REFER to Multifunction Electronic Modules Service and Repair. TEST the system for normal operation.
-------------------------------------------------
AH4 CHECK THE IGNITION SWITCH
- Ignition OFF.
- Disconnect: Ignition Switch C250 .
- Carry out the ignition switch component test.
Refer to Ignition switch for component testing.
- Is the ignition switch OK?
Yes
REPAIR circuit CDC30 (BU/GY) for an open. CLEAR the DTCs. REPEAT the self-test.
No
INSTALL a new ignition switch. REFER to Steering Column Switches Ignition Switch. CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------