Pinpoint Test AY: DTC U0230

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test AY: DTC U0230

Normal Operation
- DTC U0230 (Lost Communication With Rear Gate Module ( LTM)) - sets in continuous memory if data messages received from the Liftgate/Trunk Module (LTM) over the Medium Speed Controller Area Network (MS-CAN) are missing for greater than 5 seconds.

This pinpoint test is intended to diagnose the following:

- LTM
- Instrument Cluster (IC)


PINPOINT TEST AY: DTC U0230

-------------------------------------------------
AY1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to AY2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
AY2 CHECK THE COMMUNICATION NETWORK


- Enter the following diagnostic mode on the scan tool: Network Test .
- Carry out the network test.
- Does the LTM pass the network test?

Yes
GO to AY3.

No
REFER to Module Communications Network Testing and Inspection.

-------------------------------------------------
AY3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST


- Check for recorded IC DTCs from the self-test.
- Is DTC B1317 or DTC B1318 recorded?

Yes
GO to Pinpoint Test AM (B1317) or GO to Pinpoint Test AN (B1318). Pinpoint Test AM: DTC B1317 Pinpoint Test AN: DTC B1318

No
GO to AY4.

-------------------------------------------------
AY4 RECHECK THE IC DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the IC self-test.
- Is DTC U0230 still present?

Yes
INSTALL a new LTM. REFER to Body Closures Service and Repair. CLEAR the DTCs. REPEAT the IC self-test.

If DTC U0230 is still present, INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------