Ignition Switch Lock Cylinder: Service and Repair

Ignition Lock Cylinder









Removal and Installation

NOTE: For non-functional ignition lock cylinders, the steering column lock module has to be replaced. For additional information, refer to Steering Column Switches Steering Column Lock Module.

1. Remove the steering column opening trim panel. For additional information, refer to Instrument Panel and Console Instrument Panel - Exploded View.

2. Remove the 3 screws and the lower steering column shroud.

3. Turn the key to the ACC position.

4. Insert a small punch into the hole and remove the ignition lock cylinder.





5. If a new lock cylinder with keys is replaced, the new Passive Anti-Theft System (PATS) keys must be programmed. For additional information, refer to Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment in Anti-Theft - Passive Anti-Theft System (PATS) Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment.

6. To install, reverse the removal procedure.