Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> Mustang V6-3.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Transmission Speed Sensor >> Service and Repair >> MT82 Getrag 6-Speed
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

MT82 Getrag 6-Speed




Output Shaft Speed (OSS) Sensor













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the drain plug and drain the transmission fluid.
- Install the drain plug.

- Tighten to 35 Nm (26 lb-ft).





3. Disconnect the Output Shaft Speed (OSS) electrical connector.





4. Remove the OSS sensor bolt, then remove OSS sensor.
- To install, tighten to 10 Nm (89 lb-in).





5. To install, reverse the removal procedure.

6. NOTICE: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or transmission failure.

Check, and as necessary, fill the transmission with transmission fluid.

pro multis · About Operation CHARM