Wheel Speed Sensor - Front

Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Disconnect the wheel speed sensor electrical connector.

3. Remove the wheel speed sensor harness bolt and unclip the retainers.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 30 Nm (22 lb-ft).

5. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply a light coating of the specified grease to the mounting surface.

To install, reverse the removal procedure.