Voltage Regulator: Service and Repair

Voltage Regulator









Removal and Installation

1. Remove the generator. For additional information, refer to Generator - 4.0L SOHC Service and Repair.

2. Remove the 4 screws and the generator voltage regulator (includes the generator brush and terminal holder).
- To install, tighten to 3 Nm (27 lb-in).

3. NOTE: When installing the voltage regulator (including the generator brush and terminal holder) assembly, it is necessary to insert a wire (preferably plastic) into the generator brush holding wire insertion hole in order to hold the generator brushes while the voltage regulator assembly (including the generator brush and terminal holder) is being assembled to the generator. Make certain to remove the wire before the vehicle is started or the generator will not operate.

To install, reverse the removal procedure.