Seat Track - Bucket and 40 Percent

Seat Track - Bucket and 40 Percent

Removal

NOTE: For parts identification and location, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the seat backrest assembly. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent Seat Backrest - Front, Bucket and 40 Percent.

2. Remove the seat track assist spring.





3. Remove the 4 cushion frame bolts and separate the seat track and cushion frame.
- Release any remaining wire harness retainers.
- Note the wire harness routing for correct installation.

4. Remove the seat track adjustment handle.
- Remove one side of the seat track adjustment handle at a time.





5. Remove the 8 nuts and 2 seat tracks from the cushion tube assembly.

Installation

1. Install the 2 seat tracks and 8 nuts to the cushion tube assembly.
- Tighten to 25 Nm (18 lb-ft).

2. Install the seat track adjustment handle.
- Install one side of the seat track adjustment handle at a time.

3. Install the cushion frame and 4 bolts to the seat track.
- Tighten to 6 Nm (53 lb-in).

- Correctly install the wire harness as noted in removal.

4. Install the seat track assist spring.

5. Install the seat backrest. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent Seat Backrest - Front, Bucket and 40 Percent.

6. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures portion of Supplemental Restraint System Service and Repair.