Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

NOTE: Rear Wheel Drive (RWD) shown, Four-Wheel Drive (4WD) similar.











Removal and Installation

1. Remove the wheel and tire. For additional information, refer to Wheels and Tires Removal and Replacement.

2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
- To install, tighten to 36 Nm (27 lb-ft).

- Support the caliper using mechanic's wire.

3. Remove the brake pads and the brake pad clips.

4. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
- Discard the bolts.

- To install, tighten the new bolts to 115 Nm (85 lb-ft).

5. To install, reverse the removal procedure.