Control Module: Service and Repair

4X4 Control Module













Removal and Installation

1. NOTICE: Before removing the audio unit, it must be placed in shipment mode. Failure to follow this instruction may result in damage to the audio unit.

Put the audio unit in shipment mode. For additional information, refer to Information and Entertainment Systems Audio Unit Shipment Mode.

2. Insert the Audio Unit Removing Tool, then remove and support the audio unit.





3. Disconnect the audio unit electrical connector(s) and antenna cable.

4. Remove the 2 instrument panel finish panel screws. Disengage the spring clips at the top. Remove the instrument panel finish panel.





5. Disconnect the finish panel electrical connectors.

6. Disengage the locking tangs and remove the 4X4 control module harness connectors.

7. Remove the two 4X4 control module screws.





8. Remove the 4X4 control module.

9. To install, reverse the removal procedure.