Seat Cushion - Rear

Seat Cushion - Rear



Cushion Disassembly View

NOTE: LH shown, RH similar.













Backrest Removal View

NOTE: LH shown, RH similar.











Disassembly

1. To remove individual parts, only carry out the listed steps as identified in the following table.


Seat Cushion Components - Removal Steps






2. Remove the seat. For additional information, refer to Seat - Rear Rear Seat.

3. For LH seat, remove the center safety belt anchor and LH safety belt buckle.
- Remove the bolt, LH safety belt buckle, center safety belt anchor, washer, spacer and cover.
- Note the spacer shoulder position and safety belt routing for correct installation.

4. Remove the 2 bolts and backrest.

5. Remove the screw and cushion latch release handle.

6. Remove the 3 screws and strut cover.

7. Release all the J-clips from the cushion frame and invert the cushion cover.
- Note routing of the backrest release strap for correct installation.

8. Remove all the hog rings and cushion cover.

9. Remove the cushion foam pad.

10. Remove the bolt, safety belt buckle (RH or center), washer, spacer and cover.
- Note the spacer shoulder position and safety belt routing for correct installation.

11. Remove the bolt and child safety seat tether anchor.

12. Remove the 4 screws and pedestal cover(s).

Assembly

1. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install individual parts, only carry out the listed steps as identified in the following table.

Seat Cushion Components - Installation Steps






2. Install the pedestal cover(s) and 4 screws.

3. Install the child safety seat tether anchor and bolt.
- Tighten to 22 Nm (16 lb-ft).

4. Install the safety belt buckle (RH or center), washer, spacer, cover and bolt.
- Correctly position the safety belt buckle, spacer, washer, cover and bolt as noted in removal.

- Tighten to 25 Nm (18 lb-ft).

5. Install the cushion foam pad.

6. Position the cushion cover to the foam pad and install all the hog rings.
- Route the cushion cover straps through the child safety seat anchor wires.

7. Fasten all the cushion cover J-clips to the cushion frame.
- Correctly route the backrest release strap as noted in removal.

8. Install the strut cover and 3 screws.

9. Install the cushion latch release handle and screw.

10. Install the backrest assembly and 2 bolts.
- Tighten to 25 Nm (18 lb-ft).

- For correct installation, make sure the backrest limiter is positioned into the stop ring on the cushion frame.

11. For LH seat, install the center safety belt anchor and LH safety belt buckle.
- Correctly position the safety belt buckle, anchor, spacer, washer, cover and bolt as noted in removal.

- Tighten to 25 Nm (18 lb-ft).

12. Install the seat. For additional information, refer to Seat - Rear Rear Seat.