Power Steering Pump Pulley

Power Steering Pump Pulley













Removal

NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material, or failure of the power steering components may result.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the 2 bolts and the accessory drive belt splash shield.

3. Rotate the accessory drive belt tensioner clockwise and position the accessory drive belt away from the power steering pump pulley.

4. Using the Power Steering Pump Pulley Remover, remove the power steering pump pulley.





Installation

1. NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.

Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.





2. Rotate the tensioner clockwise and position the accessory drive belt on the power steering pump pulley.

3. Position the accessory drive belt splash shield and install the 2 bolts.
- Tighten to 9 Nm (80 lb-in).