Transmission Fluid Cooler Backflushing and Cleaning

Transmission Fluid Cooler Backflushing and Cleaning









NOTICE: The use of any transmission fluid other than what is recommended for this transaxle will cause transaxle damage. Refer to the fluid specification for the correct fluid.

NOTICE: Do not use water-based cleaners, mineral spirits, brake cleaner or solvents that may contain acetone, xylene or heptane to clean and/or flush the transaxle assembly, transaxle components or the torque converter, transaxle damage will occur. Use only clean transmission fluid designated for this transmission.

1. Carry out backflushing with a 7AR Transmission Heated Cooler Line and Flusher. Test equipment to make sure that a vigorous transmission fluid flow is present before proceeding. Install a new system filter if flow is weak or contaminated.

2. Remove the transmission fluid cooler tubes. For additional information, refer to Transaxle/Transmission Cooling Transmission Fluid Cooler Tubes.

3. To aid in attaching the 7AR Transmission Heated Cooler Line and Flusher to the transmission fluid cooler, install rubber hoses on the metal inlet and outlet tubes on the transmission fluid cooler. Install the 7AR Transmission Heated Cooler Line and Flusher on the rubber hoses as follows:

1. Connect the 7AR Transmission Heated Cooler Line and Flusher tank pressure tube to the transmission fluid cooler return tube.

2. Connect a tank return hose to the transmission fluid cooler pressure tube. Place the outlet end of this hose in the transmission fluid tank reservoir.

4. Turn on the transmission fluid pump and allow the transmission fluid to circulate a minimum of 5 minutes (cycling switch on and off will help dislodge contaminants in cooling system).

5. Switch off the 7AR Transmission Heated Cooler Line and Flusher and disconnect the pressure hose from the transmission fluid cooler return tube.

6. Clean the transmission fluid cooler tubes by hand.

7. Use compressed air to blow out the cooler(s) and tubes (blow air into the transmission fluid cooler return tube) until all fluid is removed.

8. Remove the rubber hoses from the transmission fluid cooler and install the transmission fluid cooler tubes. For additional information, refer to Transaxle/Transmission Cooling Transmission Fluid Cooler Tubes.

9. Check the transmission fluid level.