Selector Lever Knob

Selector Lever Knob









Removal

1. Remove the floor console. For additional information, refer to Instrument Panel and Console Console - Floor.

2. NOTE: Selector lever assembly removed for clarity.

Disconnect the Overdrive (O/D) switch electrical connector.





3. Remove the selector lever knob.
- Remove and discard the screw.

- Pull off the knob.





Installation

1. Position the selector lever knob onto the selector lever and route the wiring harness through the selector lever bezel.





2. Slide the selector lever knob down the selector lever and install a new screw.





3. NOTE: Selector lever assembly removed for clarity.

Connect the O/D switch electrical connector.





4. Install the floor console. For additional information, refer to Instrument Panel and Console Console - Floor.