Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously
Intermediate Shaft
Intermediate Shaft
Removal
1. Remove the RH halfshaft and intermediate shaft assembly. For additional information, refer to Halfshaft - RH Halfshaft - RH.
2. Position the intermediate shaft in a soft-jawed vise.
3. NOTICE: Use care not to damage the boot or component damage may occur.
Cut, remove and discard the inner CV boot clamp and slide back the boot.
- Separate the RH halfshaft from the intermediate shaft.
Installation
1. Apply grease (130 g [4.58 oz] provided with the boot kit) in the CV joint housing and boot.
2. Position the tripod in the housing.
1. Install the tripod into the bottom of the CV joint housing.
2. Position the new boot clamp on the boot.
3. NOTICE: Use care not to damage the boot or component damage may occur.
Install the halfshaft.
1. Insert a small screwdriver under the boot seat to allow the air to escape.
2. Slide the tripod joint in as far as possible, then pull it out 20 mm (0.787 in).
- Remove the screwdriver.
4. Using the Constant Velocity Joint Boot Clamp Installer, install the boot clamp.
5. Install the RH halfshaft and intermediate shaft assembly. For additional information, refer to Halfshaft - RH Halfshaft - RH.