Shift Lever Cable and Bracket - TorqShift

Shift Lever Cable and Bracket - TorqShift









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the 2 screws and Data Link Connector (DLC).





3. Pull to release the retaining clips and remove the steering column opening lower finish panel.

4. Remove the 4 steering column-to-cross car beam nuts and lower the steering column.
- To install, tighten to 15 Nm (133 lb-in).






5. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the steering column shift tube bracket and the steering column bracket.

Disconnect the selector lever cable from the steering column.
1. Disconnect the selector lever cable from the steering column shift tube lever.

2. Carefully lift the locking tab and disconnect the selector lever cable from the steering column bracket.






6. Disconnect the cable pushpin from the stud in the bulkhead.

7. Push the rubber grommet and transmission selector lever cable through the bulkhead.

8. Remove the selector lever cable and bracket from the transmission.
1. Disconnect the selector lever cable from the manual control lever.

2. Disconnect the wire harness from the selector lever cable bracket.

3. Remove the selector lever cable bracket bolts and position the selector lever cable and bracket aside.
- To install, tighten to 48 Nm (35 lb-ft).







9. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever cable bracket and listen for the cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket.

To install, reverse the removal procedure.

- Adjust the selector lever cable. Refer to Selector Lever Cable Adjustment Adjustments.