Compressor to Condenser Discharge Line

Compressor to Condenser Discharge Line













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Recover the refrigerant.

3. Remove the RH front wheel and tire.

4. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).


5. Disconnect the high-pressure cutoff switch electrical connector.

6. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).


7. Remove the compressor-to-condenser discharge line.

8. To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.

- Add the correct amount of clean PAG oil to the refrigerant system.


9. Evacuate, leak test and charge the refrigerant system.