Collision Avoidance and Parking Assist System

Parking Aid

Pinpoint Test H: DTC U0155

Normal Operation

The Parking Aid Module (PAM) receives the transmission selector (PRNDL) state from the Instrument Panel Cluster (IPC) as a gateway message from the Transmission Control Module (TCM).

- DTC U0155 (Lost Communication With Instrument Panel Cluster (IPC (Instrument Panel Cluster))) Control Module- a continuous and on-demand DTC that sets in the PAM (Parking Aid Module) when PRNDL messages are not received from the IPC (Instrument Panel Cluster).

This pinpoint test is intended to diagnose the following:

- IPC (Instrument Panel Cluster)

- Networked data fault

PINPOINT TEST H : DTC U0155

H1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.

- Verify that there is an observable symptom present.

Is an observable symptom present?

Yes
GO to H2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

H2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: Network Test.

- Carry out the network test.

Does the IPC (Instrument Panel Cluster) pass the network test?

Yes
GO to H3.

No
REFER to Information Bus.

H3 RECHECK THE PAM (Parking Aid Module) DTCs

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI (Programmable Module Installation) may not have been carried out.

- Clear the DTCs. Repeat the PAM (Parking Aid Module) self-test.

Is DTC U0155 still present?

Yes
GO to H4.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic.

H4 CHECK FOR DTC U0155 SET IN OTHER MODULES

- Clear all DTCs.

- Ignition OFF.

- Ignition ON.

- Wait 10 seconds.

- Enter the following diagnostic mode on the scan tool: Self-Test.

- Retrieve the continuous memory DTCs from all modules.

Is DTC U0155 set in any module?

Yes
INSTALL a new IPC (Instrument Panel Cluster). TEST the system for normal operation.

No
INSTALL a new PAM (Parking Aid Module). REFER to Parking Aid Module (PAM) Service and Repair. TEST the system for normal operation.