Detachable Safety Belt Anchor - Rear, Bench

Detachable Safety Belt Anchor - Rear, Bench

Removal and Installation

WARNING: After a crash, the following safety belt components and attaching hardware must be inspected and tested to verify correct function:
- Retractors
- Buckles
- Child safety seat tether bracket assemblies
- Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
- Belt tension sensor (BTS) (if equipped)
- Front safety belt buckle support assemblies (slide bar) (if equipped)
- Safety belt shoulder belt height adjusters (if equipped)
Components that do not operate correctly or pass all Functional Tests in the Component Tests must be replaced with new components.
Safety belt assembly attaching areas must be inspected. Damaged or distorted attaching areas must be restored to their original structural integrity and a new safety belt assembly with new attaching hardware must be installed.
After deployment of the front safety belt pretensioners, a new safety belt system (including retractors, buckles and height adjusters) must be installed.
Failure to follow this instruction may result in incorrect operation of the safety belt system and increases the risk of serious personal injury or death in a crash.

NOTE: RH shown, LH similar.

1. Remove the detachable safety belt anchor.
1. Insert an appropriate tool and release the detachable safety belt anchor from the seat.

2. Remove the bolt and RH/LH detachable safety belt anchor.
- To install, tighten to 60 Nm (44 lb-ft).







2. NOTE: The anti-rotation tab(s) must be correctly aligned for correct installation.

To install reverse the removal procedure.


3. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Safety Belt System Component Tests and General Diagnostics.