Automatic Transaxle/Transmission - TorqShift(R)

Line Pressure Control Solenoid - PC-A





Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the transmission solenoid body. For additional information, refer to Solenoid Body Assembly Automatic Transaxle/Transmission - TorqShift(R).

3. Remove the solenoid body electrical connector O-ring seal.





4. Partially remove the solenoid body electrical wire harness.
1. Remove the wire harness-to-solenoid body bolts.

2. Disconnect the electrical connector from the Pressure Control Solenoid A (PCA) and the Shift Solenoid Pressure Control C (SSPCC).

3. Lift the tab on the bulkhead connector, twist and push the bulkhead connector through the solenoid body.






5. Remove the PCA (Pressure Control Solenoid A).
1. Remove the retaining E-clips from the PCA (Pressure Control Solenoid A) and the SSPCC (Shift Solenoid Pressure Control C).

2. Partially slide the SSPCC (Shift Solenoid Pressure Control C) back enough to gain clearance to remove the PCA (Pressure Control Solenoid A).

3. Remove the PCA (Pressure Control Solenoid A).






Installation

1. Assemble the main control valve body.
1. Install the PCA (Pressure Control Solenoid A) and install the retaining E-clip.

2. Push the bulkhead connector through the solenoid body and twist the bulkhead connector locking it into place.

3. Install the SSPCC (Shift Solenoid Pressure Control C) back into place and install the retaining E-clip.

4. Connect the PCA (Pressure Control Solenoid A) and the SSPCC (Shift Solenoid Pressure Control C).

5. Install the wire harness to solenoid body and tighten the bolts.






2. Remove the solenoid body electrical connector O-ring seal.





3. Install the transmission solenoid body. For additional information, refer to Solenoid Body Assembly Automatic Transaxle/Transmission - TorqShift(R).