Automatic Transaxle/Transmission - TorqShift(R)

Shift Solenoids (SS)

Removal and Installation

NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.

NOTE: The Pressure Control Solenoid A (PCA) (line pressure solenoid) is not serviced in the vehicle. The solenoid body will need to be removed to remove the PCA (Pressure Control Solenoid A). For additional information, refer to Solenoid Body Assembly Automatic Transaxle/Transmission - TorqShift(R).

1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter Automatic Transaxle/Transmission - TorqShift(R).

2. Disconnect the affected shift solenoid connector.





3. Remove the affected shift solenoid.
1. Remove the retaining E-clip.

2. Remove the affected shift solenoid.






4. To install, reverse the removal procedure.