Transaxle Front Support Insulator

Transaxle Front Support Insulator













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Using the Engine Support Bar and Adapters, support the engine.





3. Remove the front-to-aft crossmember.
1. Remove the 2 transaxle front support insulator bolts.
- To install, tighten to 90 Nm (66 lb-ft).

2. Remove the splash shield screw.

3. Remove the 2 front-to-aft crossmember bolts and the nut.
- To install, tighten bolts to 90 Nm (66 lb-ft).

- To install, tighten nut to 175 Nm (129 lb-ft).

4. Remove the crossmember.






4. Remove the through bolt and the transaxle front support insulator.
- To install, tighten to 115 Nm (85 lb-ft).


5. If necessary, remove the 3 bolts and the transaxle front support insulator bracket.
- To install, tighten to 48 Nm (35 lb-ft).


6. To install, reverse the removal procedure.