Catalytic Converter - RH Manifold

Catalytic Converter - 3.0L RH

Removal and Installation

1. Remove the exhaust Y-pipe. For additional information, refer to Exhaust Y-Pipe- 3.0L .

2. Disconnect the RH Catalyst Monitor Sensor (CMS) electrical connector.

3. Remove and discard the 3 RH catalytic converter nuts and remove the converter.
- Discard the RH catalytic converter manifold gasket.

- To install, tighten to 40 Nm (30 lb-ft).


4. To install, reverse the removal procedure.
- Install a new gasket and nuts.