Pinpoint Test AA: The Cruise Control Indicator Is Never/Always On
Instrumentation, Message Center and Warning Chimes
Pinpoint Test AA: The Cruise Control Indicator Is Never/Always On
Normal Operation
The Instrument Cluster (IC) receives the cruise control signal from the PCM over the High Speed Controller Area Network (HS-CAN) communication bus. When the cruise control is engaged, the PCM sends a message to the IC (Instrument Cluster) to illuminate the cruise control indicator. If the cruise control message is missing or if the data is deemed invalid by the IC (Instrument Cluster) for more than 5 seconds, the IC (Instrument Cluster) sets DTC U0100 in continuous memory and defaults the cruise control off.
NOTE: If DTC U0100 is set in the IC (Instrument Cluster), other observable symptoms may be an inoperative speedometer, tachometer or odometer.
This pinpoint test is intended to diagnose the following:
- PCM
- IC (Instrument Cluster)
PINPOINT TEST AA : THE CRUISE CONTROL INDICATOR IS NEVER/ALWAYS ON
AA1 CHECK THE CRUISE CONTROL OPERATION
- Verify that the cruise control operates.
Does the cruise control operate correctly?
Yes
GO to AA2.
No
REFER to Fire Suppression System.
AA2 CARRY OUT THE IC (Instrument Cluster) INDICATOR LAMP CONTROL ACTIVE COMMAND USING THE SCAN TOOL
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC (Instrument Cluster) DataLogger.
- Select the IC (Instrument Cluster) cruise control indicator (CRUISE) active command. Command the cruise control indicator on and off. Observe the cruise control indicator.
Does the cruise control indicator illuminate when commanded on and turn off when commanded off?
Yes
GO to AA3.
No
INSTALL a new IC (Instrument Cluster). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
AA3 RETRIEVE THE RECORDED DTCs FROM THE IC (Instrument Cluster) SELF-TEST
- Check for recorded IC (Instrument Cluster) DTCs from the self-test.
Are any DTCs recorded?
Yes
For DTC U0100, GO to Pinpoint Test AV Pinpoint Test AV: DTC U0100.
For all other DTCs, REFER to DTC Charts Instrumentation, Message Center and Warning Chimes.
No
INSTALL a new PCM. TEST the system for normal operation.