Pinpoint Test BA: DTC U0129
Instrumentation, Message Center and Warning Chimes
Pinpoint Test BA: DTC U0129
Normal Operation
- DTC U0129 (Lost Communication With Brake System Control Module)- sets in continuous memory in the Instrument Cluster (IC) if data messages received from the brake system control module (also known as the ABS module) over the High Speed Controller Area Network (HS-CAN) are missing. For a complete list of all network messages, refer to Information Bus.
This pinpoint test is intended to diagnose the following:
- ABS module
- IC (Instrument Cluster)
PINPOINT TEST BA : DTC U0129
BA1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify that there is an observable symptom present.
Is an observable symptom present?
Yes
GO to BA2.
No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
BA2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
Does the ABS module pass the network test?
Yes
GO to BA3.
No
REFER to Information Bus.
BA3 RETRIEVE THE RECORDED DTCs FROM THE IC (Instrument Cluster) SELF-TEST
- Check for recorded IC (Instrument Cluster) DTCs from the self-test.
Is DTC B1317 or DTC B1318 recorded?
Yes
GO to Pinpoint Test AS Pinpoint Test AS: DTC B1317 (B1317) or GO to Pinpoint Test AT Pinpoint Test AT: DTC B1318 (B1318).
No
GO to BA4.
BA4 RECHECK THE IC (Instrument Cluster) DTCs
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI (Programmable Module Installation) may not have been carried out.
- Clear the DTCs. Repeat the IC (Instrument Cluster) self-test.
Is DTC U0129 still present?
Yes
INSTALL a new ABS module. CLEAR the DTCs. REPEAT the IC (Instrument Cluster) self-test.
If DTC U0129 is still present, INSTALL a new IC (Instrument Cluster). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
No
The system is operating correctly at this time. The DTC may have been set due to high network traffic.