Crankshaft Pulley

Crankshaft Pulley

Special Tool(s)






Material(s)






Removal

1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Lifting Points .

2. Remove the RH (Right Hand) splash shield. REFER to Fender Splash Shield .

3. Remove the accessory drive belt. REFER to Accessory Drive.

4. Using 303-D055 (D85L-6000-A) , remove the crankshaft pulley bolt and washer.

1. Discard the bolt.






5. Using 303-D121 , remove the crankshaft pulley.





Installation

1. Lubricate the crankshaft front seal inner lip with clean engine oil.

2. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using 303-102 (T74P-6316-B) and 303-335 (T88T-6701-A) , install the crankshaft pulley.





3. Using 303-D055 (D85L-6000-A) , install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.





4. Install the accessory drive belt. REFER to Accessory Drive.

5. Install the RH (Right Hand) splash shield. REFER to Fender Splash Shield .