Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line - 3.5L Ti-VCT

Material(s)






Exploded View










Removal

1. Recover the refrigerant. REFER to Air Conditioning (AC) System Recovery, Evacuation, and Charging .

2. Remove the rear A/C compressor bolt.



3. Remove the A/C compressor discharge fitting nut and disconnect the fitting.

- Discard the O-ring seal and gasket seal.

4. Disconnect the A/C pressure transducer electrical connector.

5. Remove the condenser inlet fitting nut and disconnect the fitting.

- Discard the O-ring seal and gasket seal.

6. Remove the compressor-to-condenser discharge line.

Installation

1. Install the compressor-to-condenser discharge line.

2. Using a new O-ring seal, connect the condenser inlet fitting and install the nut.
- Tighten to 15 Nm (133 lb-in).

3. Connect the A/C (Air Conditioning) pressure transducer electrical connector.

4. Using a new O-ring seal, connect the A/C (Air Conditioning) compressor discharge fitting and install the nut.
- Tighten to 15 Nm (133 lb-in).

5. Install the rear A/C (Air Conditioning) compressor bolt.
- Tighten to 25 Nm (18 lb-ft).

6. Recharge the A/C (Air Conditioning) system. REFER to Air Conditioning (AC) System Recovery, Evacuation, and Charging .