Auto-Unlock Programming

Auto-Unlock Programming

Programming the Auto-Unlock Feature Using the Door Lock Control Switch

NOTE: Prior to beginning, make sure the ignition key is in the OFF position and all vehicle doors are closed.

NOTE: When programming the auto-unlock feature using the door lock control switch method, the following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.

1. Turn the ignition from the OFF to the RUN position.

2. Press the unlock button on the door lock control switch 3 times.

3. Turn the ignition from the RUN to the OFF position.

4. Press the unlock button on the door lock control switch 3 times.

5. Turn the ignition to the RUN position. The horn chirps once to indicate that programming mode is entered.

6. To enable/disable the auto-unlock feature, press the lock button on the door lock control switch, then the unlock button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.

7. Turn the ignition to the OFF position. The horn chirps once to signal that the programming is complete.

Programming the Auto-Unlock Feature Using the Message Center

1. With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.

2. NOTE: Refer to the Owner's Literature a complete list of the message center menus.

Access the locks menu within the setup menu in the message center.

3. Select auto-unlock and use the left and right arrows to enable or disable the feature.