Cylinder Head Assembly: Specifications

Cylinder Head

Install the cylinder head and the 10 new bolts.
Tighten the bolts in the sequence shown in 5 stages.
Stage 1: Tighten to 7 Nm (62 lb-in).
Stage 2: Tighten to 15 Nm (133 lb-in).
Stage 3: Tighten to 55 Nm (41 lb-ft).
Stage 4: Tighten 90 degrees.
Stage 5: Tighten an additional 90 degrees.







Bolt re-usability

NOTE: The cylinder head bolts are torque-to-yield and must not be reused. New cylinder head bolts must be installed.




Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage














Camshaft Bearing Cap

Install the camshafts and bearing caps in their original location and orientation.
Tighten the camshaft bearing caps 2 turns at a time in the sequence shown in 2 stages:
Stage 1: Tighten to 7 Nm (62 lb-in).
Stage 2: Tighten to 16 Nm (142 lb-in).







Intake Manifold Specifications

Camshaft Gear/Sprocket Specifications