Toe Adjustment - Rear

Toe Adjustment - Rear

General Procedure

1. Using alignment equipment and the manufacturer's instructions, measure the rear toe.

2. Start the engine and center the steering wheel.

3. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4. Loosen the tie-rod jam nuts.





5. Rotate the toe link adjusting rod until the toe setting is within specifications.





6. NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.
Tighten the tie-rod jam nuts.
- Tighten to 80 Nm (60 lb-ft).

7. Recheck the rear toe and adjust as necessary.