Rear Lamp Assembly

Rear Lamp Assembly

NOTE: Styleside lamp shown, flareside similar.









Removal and Installation

1. Remove the 2 rear lamp assembly bolts.
- To install, tighten to 5 Nm (44 lb-in).


2. Firmly pull the rear lamp assembly rearward to disengage the metal studs from the grommets on the outboard side of the sheet metal.
- Disconnect the electrical connectors.


3. If necessary, rotate the bulb holder counterclockwise approximately one-eighth turn and remove it.
- Separate the bulb from the bulb holder.


4. To install, reverse the removal procedure.