Oil Pressure Sensor: Service and Repair

Engine Oil Pressure (EOP) Switch









Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Disconnect the Engine Oil Pressure (EOP) switch wiring harness retainer and the electrical connector.

3. Remove the EOP (Engine Oil Pressure) switch.

Installation

1. Install the EOP (Engine Oil Pressure) switch.
- Stage 1: Tighten to 14 Nm (124 lb-in).

- Stage 2: Tighten an additional 180 degrees.


2. Connect the EOP (Engine Oil Pressure) switch electrical connector and attach the wiring harness retainer.