B-Pillar Trim Panel - SuperCrew

B-Pillar Trim Panel - SuperCrew

Removal and Installation

1. Position seats fully down and forward.

2. Depower the Supplemental Restraint System (SRS). For additional information, refer to Restraints and Safety Systems &/or Air Bag Systems.

3. Pull upward to release the scuff plate clips and remove the front door scuff plate.
- Detach the scuff plate from the weatherstrip.






4. Position the front and rear weatherstrips aside.

5. Remove the safety belt D-ring trim cover.

6. Remove the safety belt D-ring bolt.
- To install, tighten to 40 Nm (30 lb-ft).


7. NOTE: Starting at the top of the cover, use a non-marring tool.
Remove the B-pillar bolt cover.


8. Remove the B-pillar bolt.





9. Remove the safety belt anchor bolt trim cover.





10. Remove the safety belt anchor bolt.
- Disconnect electrical connector.

- To install, tighten to 40 Nm (30 lb-ft).


11. Pull upward to release the scuff plate clips and remove the rear door scuff plate.
- Detach the scuff plate from the weatherstrip clip.






12. Remove the safety belt trim ring and pull the safety belt through the B-pillar.





13. Remove the B-pillar trim panel.

14. NOTE: The B-pillar trim panel has a 2-way locator and a 4-way locator that must be positioned correctly on installation.
To install, reverse the removal procedure.