Pinpoint Test AS: The Turn Signal On Warning Chime Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Test AS: The Turn Signal On Warning Chime Is Inoperative

Normal Operation

The turn signal on warning chime sounds when the vehicle travels more than 3.2 km (2.0 miles) with the turn signal on. The Body Control Module (BCM) communicates the turn signal switch status to the IPC (Instrument Panel Cluster) over the High Speed Controller Area Network (HS-CAN). The PCM communicates the odometer count data to the IPC (Instrument Panel Cluster) over the HS-CAN (High Speed Controller Area Network).

This pinpoint test is intended to diagnose the following:

- Odometer operation

- Turn signal indication concern

- BCM (Body Control Module)

- IPC (Instrument Panel Cluster)

PINPOINT TEST AS : THE TURN SIGNAL ON WARNING CHIME IS INOPERATIVE

AS1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION

- Ignition OFF.

- With the ignition switch off and the key in the ignition lock cylinder, open the LH front door and observe the key-in-ignition warning chime operation.

Does the key-in-ignition warning chime operate correctly?

Yes
GO to AS2.
No
INSTALL a new IPC (Instrument Panel Cluster). REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.

AS2 CHECK THE TURN SIGNAL INDICATORS OPERATION

- Ignition ON.

- Verify the turn signal indicators operation.

Do the turn signal indicators operate correctly?

Yes
GO to AS3.
No
GO to Pinpoint Test R. Pinpoint Test R: The LH/RH Turn Or High Beam Indicator Is Never/Always On

AS3 CHECK THE ODOMETER FOR CORRECT OPERATION

- Drive the vehicle and observe the odometer for correct operation.

Does the odometer operate correctly?

Yes
INSTALL a new BCM (Body Control Module). TEST the system for normal operation.
No
GO to Pinpoint Test H. Pinpoint Test H: The Odometer Is Inoperative