Ignition Switch Lock Cylinder: Service and Repair

Ignition Lock Cylinder - Non Functional

Removal and Installation

1. Remove the steering wheel.

2. Remove the ignition lock cylinder.
- Use an 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.

- Use a 3/8-inch diameter drill bit to drill down the middle of the ignition lock cylinder key slot until the ignition lock cylinder breaks loose.

- Remove and discard the ignition lock cylinder from the steering column.

3. Thoroughly clean all drill shavings from the steering column and inspect it for damage.

Installation

1. Using a suitable tool, carefully rotate the "D shaped" rotor in the steering column, one click clockwise, to the ACC position.

2. Position the new ignition lock cylinder to the ACC position.

3. Insert the ignition lock cylinder into the ignition lock cylinder access hole located on the steering column.
- Make sure to align the locking pin with the locking pin access hole.

4. Install the steering wheel.

5. Rotate the ignition key through all lock cylinder positions to check for correct operation.