22500 MI or 36000 KM

Inspect
    Universal Joint, Drive/Propeller Shaft
      Inspect and lubricate U-joints, If using Special Operating Conditions D, O.
    Tie Rod End
      Inspect and lubricate if equipped with grease fittings, If using Special Operating Conditions D, O.
    Steering and Suspension
      Inspect steering and suspension, ball joints, and tie rods; lubricate if equipped with grease fittings, If using Special Operating Conditions D, O.
    Exhaust System
      (Inspect functional holes in each leg of the twin tip and the holes under the shield just inboard of the right rear tire to make sure they are kept clean/clear of debris or foreign materials, if using Special Operating Condition O.)
    Brakes and Traction Control
      Inspect brake system pads and rotors, D, O.
    Ball Joint
      Inspect and lubricate if equipped with grease fittings, If using Special Operating Conditions D, O.
    Air Cleaner Restriction Indicator
      Inspect air filter restriction gauge, replace filter as necessary if using Special Operating Condition D, O.
Replace
    Fuel Filter
      Replace engine and frame-mounted fuel filters.
    Engine Oil
      Change engine oil and filter if using Special Operating Condition D, O or U.
Rotate
    Tires
      Rotate tires, inspect tire wear and measure tread depth; vehicles equipped with dual rear wheels should only rotate the rear wheels if unusual wear is observed, if using Special Operating Conditions D, O.