Computers and Control Systems: Diagrams

Engine Control Components - Exploded View, 6.8L (3V)









Camshaft Position (CMP) Sensor

NOTE: Lubricate the CMP (Camshaft Position) sensor O-ring seal with clean engine oil prior to installation.










Crankshaft Position (CKP) Sensor

NOTE: The accessory drive belt must be removed to perform this procedure.

NOTE: The A/C compressor must be positioned aside to access the Crankshaft Position (CKP) sensor, it is not necessary to remove the A/C compressor from the vehicle.

NOTE: Lubricate the CKP (Crankshaft Position) sensor O-ring seal with clean engine oil prior to installation.

NOTE: After installing the CKP (Crankshaft Position) sensor, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.










Cylinder Head Temperature (CHT) Sensor

NOTE: The intake manifold must be removed to perform this procedure. For additional information, refer to Engine.

NOTE: Do not reuse the CHT (Cylinder Head Temperature) sensor, install a new one. Coat the new CHT (Cylinder Head Temperature) sensor threads with high temperature nickel anti-seize lubricant prior to installation.










Heated Oxygen Sensor (HO2S) and Catalyst Monitor Sensor (CMS)

NOTE: If necessary, lubricate the Heated Oxygen Sensor (HO2S) and/or Catalyst Monitor Sensor (CMS) with penetrating and lock lubricant to assist in removal.

NOTE: Apply anti-seize to the threads of the HO2S (Heated Oxygen Sensor) and/or CMS (Catalyst Monitor Sensor) prior to installing.

NOTE: The correct torque wrench setting must be calculated when using the Exhaust Gas Oxygen Sensor Socket to install the HO2S (Heated Oxygen Sensor) and/or CMS (Catalyst Monitor Sensor).










Intake Manifold Runner Control (IMRC) Actuator

NOTE: The air cleaner outlet pipe must be removed to perform this procedure.

NOTE: Lubricate the IMRC (Intake Manifold Runner Control) actuator rod pivot pin with clean engine oil prior to installation.










Knock Sensor (KS)

NOTE: The intake manifold must be removed to perform this procedure. For additional information, refer to Engine.









Removal and Installation

1. Refer to the procedures and/or exploded views for any Warnings, Notices, Notes, Materials, Specifications, and Special Tools. Items in the exploded views may not be listed in order of removal.