Head Restraint - Driver, With DVD

Head Restraint - Driver, With DVD

Removal

1. Remove the front seat. For additional information, refer to Seat- Front Seat - Front.

2. NOTE: The seat track rear height adjust must be all the way up or the recliner cover post will not slide out of the seat track hole.

Remove the recliner cover.

1. Remove the scrivet at the rear of the recliner cover.

2. Remove the screw at the rear of the recliner cover.

3. Slide the recliner cover post out of the seat track hole and remove the recliner cover.






3. Remove the scrivet and separate the backrest cover lower J-clips.





4. Invert the backrest cover to the first row of hog rings.

5. Remove the 3 first row hog rings.





6. Invert the backrest cover up to the second row of hog rings.

7. Detach the pin-type retainer and remove the wires from the retainer.





8. Disconnect the 2 DVD player electrical connectors in the following sequence.
1. Remove the insulation from around the security clamps.

2. Open the top of the security clamps.

3. Disconnect the electrical connectors.


9. Push in on the 2 head restraint guide sleeve buttons and remove the head restraint.
- Route the wires out of the seat.






Installation

1. Route the DVD player wires into the head restraint guide sleeves.





2. Push in on the 2 head restraint guide sleeve buttons while installing the head restraint.
- Position the head restraint to its highest locking position.


3. Connect the 2 DVD player electrical connectors in the following sequence.
1. Connect the 2 white DVD player electrical connectors together.

2. Connect the 2 black DVD player electrical connectors together.

3. Close the top of the security clamps.

4. Wrap the insulation around the security clamps.


4. Secure the DVD player wires in the following sequence.
1. Put the wires in the retainer.

2. Attach the pin-type retainer to the backrest.

3. Secure the retainer around the wires.






5. Attach the DVD player jumper harness pin-type retainer.





6. Make sure the head restraint adjusts without excessive effort and locks in place.

7. Install the 3 first row hog rings.

8. Attach the backrest cover lower J-clips and install the scrivet.

9. Install the driver seat. For additional information, refer to Seat- Front Seat - Front.