Part 4

Engine










WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

NOTICE: Whenever turbocharger air intake system components are removed, always cover open ports to protect from debris. It is important that no foreign material enter the system. The turbocharger compressor vanes are susceptible to damage from even small particles. All components should be inspected and cleaned, if necessary, prior to installation or reassembly.

76. Remove the 2 bolts and the RH halfshaft support bracket.





77. Remove the 3 bolts and the Power Transfer Unit (PTU) support bracket.





78. Remove the 5 bolts and the PTU (Power Transfer Unit).





79. NOTE: Position a block of wood under the transaxle.
Install the Powertrain Lift and Adjustable Grip Arms.






80. Remove the 3 nuts and the bolt from the transaxle support insulator bracket-to-transaxle.





81. Remove the 4 engine mount nuts.





82. Remove the 3 bolts and the engine mount.





83. Lower the engine and transaxle assembly from the vehicle.

84. Remove the starter motor solenoid cover.





85. Remove the 2 nuts and the starter motor wiring terminals.





86. Disconnect the wiring harness retainer from the starter motor stud bolt.





87. Remove the bolt, stud bolt and the starter.





88. Remove the engine cover mounting stud from the LH valve cover stud bolt.





89. Detach the wiring harness retainer from the valve cover stud bolt.





90. Remove the nut and the oil supply tube bracket from the LH valve cover stud bolt.





91. Remove the 3 bolts and the LH exhaust manifold heat shield.





92. Install the Engine Lift Eye on the LH cylinder head.





93. Disconnect the 2 quick connect couplings and remove the crankcase vent tube.





94. Disconnect the transaxle control electrical connector.





95. Detach the transaxle control wire harness retainer from the transaxle stud bolt.





96. Detach the 2 wiring harness retainers from the transaxle stud bolts.





97. Remove the bolt and the ground wire from the RH cylinder head.





98. Using the Floor Crane and Spreader Bar, remove the engine and transaxle from the lift table.





99. Remove the LH transaxle-to-engine bolt.





100. Remove the 3 transaxle-to-engine bolts.
- Separate the transaxle from the engine.