Pinpoint Test AE: An Active Park Assist Message Is Inoperative

Instrumentation, Message Center and Warning Chimes

Pinpoint Test AE: An Active Park Assist Message Is Inoperative

Normal Operation

The active park assist system is enabled when the active park assist switch is pressed, the transaxle is in DRIVE (D) and the vehicle speed is below 30 km/h (18 mph). The Instrument Cluster (IC) controls the active park assist messages in the message center based upon the network message received from the Parking Aid Module (PAM) through the High Speed Controller Area Network (HS-CAN).

This pinpoint test is intended to diagnose the following:

- Message center concern

- Active park assist system concern

PINPOINT TEST AE : AN ACTIVE PARK ASSIST MESSAGE IS INOPERATIVE

AE1 CHECK THE MESSAGE CENTER OPERATION

- Close all doors, hood and liftgate.

- Ignition ON.

- Open the driver door while monitoring the message center displays.

Does the message center display DRIVER DOOR AJAR?

Yes
GO to AE2.

No
GO to Pinpoint Test AA. Pinpoint Test AA: The Message Center Is Not Operating Correctly

AE2 RETRIEVE THE RECORDED DTCs FROM THE IC (Instrument Cluster) SELF-TEST

- Check for recorded DTCs from the IC (Instrument Cluster) self-test.

Are any IC (Instrument Cluster) DTCs recorded?

Yes
For DTC U0159, GO to Pinpoint Test AV. Pinpoint Test AV: DTC U0159

For all other DTCs, REFER to DTC Charts. Instrumentation, Message Center and Warning Chimes

No
REFER to Active Parking Assist to diagnose the active park assist system.