Seat Cushion Cover - Second Row, 40 Percent

Seat Cushion Cover - Second Row, 40 Percent

Removal and Installation

NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row Seat - Exploded View, Second Row.

1. Open the cushion cover.
1. Release the clip and separate the strut.

2. Separate the J-clips.

3. Separate the hook-and-loop strips.






2. NOTE: Typical cushion cover retainer shown, others similar.
From under the seat, detach the 4 cushion cover retainers and pull them out from between the cushion frame and seat track.






3. Remove the cushion foam pad and cushion cover from the cushion frame.
- If equipped, disconnect the cushion heater mat electrical connector.


4. Remove the hog rings and the cushion cover.

5. To install, reverse the removal procedure.
- Make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion trim cover and accessible for use after installation.