Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2012 >> Fusion FWD L4-2.5L >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Transmission Speed Sensor >> Service and Repair >> Automatic Transaxle/Transmission - 6F35
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Automatic Transaxle/Transmission - 6F35




Turbine Shaft Speed (TSS) Sensor













Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.





3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





4. Remove the bolt and the TSS (Turbine Shaft Speed) sensor.





Installation

1. Install the TSS (Turbine Shaft Speed) sensor and the bolt.
- Tighten to 10 Nm (89 lb-in).






2. Connect the TSS (Turbine Shaft Speed) sensor electrical connector.





3. Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.





4. Fill the transaxle with clean transmission fluid.





5. Start the engine and move the range selector lever into each gear position.

6. Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 85-93°C (185-200°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.
pro multis · About Operation CHARM