45000 MI or 72000 KM

Tighten/Torque
    Axle Beam
      Torque the rear U-bolts on the axle beam.
Inspect
    Wheels
      Inspect wheels and related components for abnormal noise, wear, looseness or drag, if not using special operating conditions T, I, D. Inspect wheels and related components for abnormal noise, wear, looseness or drag, if using special operating conditions T, I, D.
    Vehicle
      Check and top up fluid levels: brake, coolant recovery reservoir, manual and automatic transmission (if equipped with an underhood dipstick), power steering and window washer. Inspect tires for wear and check air pressure, including spare. Check exhaust system for leaks, damage, loose parts, and foreign material. Check battery performance. Check operation of horn, exterior lamps, turn signals and hazard warning lights. Check radiator coolers, heater and air conditioning hoses. Inspect windshield washer spray and wiper operation. Check windshield for cracks, chips and pitting. Inspect for oil and fluid leaks. Inspect engine air filter. Inspect half shaft dust boots, if equipped. Check shocks and struts and other suspension components for leaks and damage. Inspect steering linkage. Inspect accessory drive belt(s). Inspect clutch operation. if equipped. If not using Special Operating Conditions.
    Universal Joint, Drive/Propeller Shaft
    Tie Rod End
      Inspect tie rod ends (lubricate if equipped with Zerk fittings). If not using Special Operating Conditions.
    Steering and Suspension
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
    Fluid - A/T
      Inspect automatic transmission fluid level (if equipped with an underhood dipstick).
    Cooling System
      Inspect engine cooling system concentration and hoses.
    Constant Velocity Joint Boot
      Inspect half shaft boots, (if equipped). If not using Special Operating Conditions.
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect brakes if using Special Operating Conditions I.
    Ball Joint
      If not using Special Operating Conditions. Lubricate control arm and steering ball joints if equipped with grease fittings, if using special operating condition I.
    Air Filter Element
      Inspect frequently, service as required
Replace
    Oil Filter, Engine
    Engine Oil
      Change engine oil and filter, if not using special conditions T, I, D. Change engine oil and filter, if using special conditions T, I, D.
Rotate
    Tires
      Rotate tires, inspect tire wear and measure tread depth, if not using special operating conditions T, I, D. Rotate tires, inspect tire wear and measure tread depth, if using special operating conditions T, I, D.