Disassembly and Assembly
DISASSEMBLY1. Remove door.
2. Remove inside door handle actuator (7).
Sliding Door Assembly:
3. Remove center roller arm cover (23).
4. Remove trim panel (24).
5. Remove lock knob (27).
6. Disconnect lock rod (25) and remove.
7. Remove rear latch (22).
8. Remove latch/lock control (14).
9. Remove exterior handle (10).
10. Remove center roller arm (20)
11. Remove stabilizer wedges (6).
12. Remove upper roller arm(20)
13. Remove bolts (28) and remove crash reinforcement (29).
ASSEMBLY
Sliding Door Assembly:
1. Install the crash reinforcement (29).
2. Install the bolts (28) and tighten to 21 Nm (15 ft. lbs.).
3. Install upper roller arm (2).
4. Install stabilizer wedges (6).
5. Install center roller arm (20).
6. Install exterior handle (10).
7. Install the latch/lock control (14).
8. Install the rear latch (22)
9. Install lock rod (25) and connect to latch/lock control.
10. Install the lock knob (27).
11. Install the trim panel (24).
12. Install inside handle actuator (7).
13. Install the center roller arm cover (23).
14. Install the door.