Heated Seat Element

For complete circuit diagrams, refer to Diagrams / Electrical.

NOTE: When checking heated seat elements for continuity, be certain to move the heating element being checked. Moving the element, such as sitting in the seat will eliminate the possibility of an intermittent open in the element which would only be evident if the element was in a certain position. Failure to check the element in various positions could result in an incomplete test.

1. Disconnect and isolate the battery negative cable. Disconnect the heated seat element wire harness connector from under the seat cushion. Check for continuity between the seat heater driver circuit and ground. There should be continuity, less than 7 ohms. If OK, go to Step 2. If not OK, replace the seat assembly.
2. Check for continuity between the seat heater B+ driver circuit cavity and the seat back frame. There should be no continuity. If OK, heating element is OK at this time. If not OK, replace the seat assembly.