Rear Blower Motor

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the cover from the rear A/C evaporator housing.

Rear Blower Motors - LH Shown, RH Similar:

3. Disconnect the wire harness connectors from the rear blower motor suppression filter and from the rear blower motor being serviced and remove the suppression filter.
4. Remove the body sealer from around the rear blower motor area being serviced.
5. Remove the screws that secure each rear blower motor to the rear evaporator housing and remove blower motor.

INSTALLATION
1. Position the rear blower motor being serviced to the rear A/C evaporator housing.
2. Install the screws that secure each rear blower motor to the rear A/C evaporator housing. Tighten the screws to 5 N.m (45 in. lbs.).
3. Install a new bead of body sealant to the blower motor area being serviced.
4. Install the rear blower motor suppression filter and connect the wiring harness connectors to the suppression filter and to the rear blower motor being serviced.
5. Install the cover onto the rear A/C evaporator housing.
6. Reconnect the negative battery cable.